Easy Fire 10-Sided Kiln 4.4 to 7.0 cubic feet cone 10 2-1/2" & 3" Brick $2500

Used only four times for a contract. Been in my garage for ten years wrapped, no water damage etc. Looks and works like new. I will throw in all the cones, slate plates and rods free. Bought this with supplies for just slightly under $4400 - yours for $2500.

Pick Up only!

  • TEMPERATURE RATING: Cone 10
  • INSIDE DIMENSIONS: 22-3/8'' diameter by 27'' high with 3'' brick, 6.7 cubic feet
  • OUTSIDE DIMENSIONS: 32'' wide by 40'' high by 45'' deep
  • RECOMMENDED FLOOR SPACE: 54'' wide by 54'' deep
  • ENERGY, TIME AND FIRING COSTS: Typical heat up to cone 6 with a 85 pound load and with Vent-Sure on at 240 Volt/single phase will be slightly less than 6-1/2 hours, 58 kW hours, $5.80 @ 10 cents per kW hour.
  • SHIPPING WEIGHT: 365 pounds for kiln. 390 pounds for kiln with vent. 455 pounds for kiln with furniture kit. 480 pounds for kiln with vent and kit. Shipping class 85.
  • SHIPPING DIMENSIONS: 44'' by 44'' by 54'' high (with Furniture Kit)
  • Element Support Hard Ceramic Element Holders
  • Element Terminations Stainless Bolts on Ceramic Blocks, no special tools needed
  • Zone Control Included (three zones)
  • Thermocouples Heavy-duty 8 gauge with Ceramic Protection Tubes (3)
  • Hinge Spring-Assist reduces weight of lid
  • Hinge Support Bars No - nothing to get in way of loading
  • Door Angle When Open To the back (doesn’t hang over opening)
  • Hinge Safety Latch Yes. Locking plunger pin, very positive & secure
  • Stand Full support, 14 ga aluminized steel with rigid bends
  • Elements Heavy-Duty
  • Brick Coating Reflective coating on entire interior, hardens brick
  • Easy Delay Start, Preheat, Hold Yes
  • Number of Easy Ceramic Programs Four
  • Number of User-Defined Programs Six
  • Instructions Complete easy-to-read visual manual, Video included
  • On/Off Switch Yes - you can turn kiln off
  • Control Fuse Yes
  • Control Panel Removable, separate piggybacked panel for control
  • Power Cord 6-50P for 1 phase, 15-50P for 3 phase
  • Sectional Construction Yes, easy to move and set up
  • Reversible Bottom Yes
  • Cone Limitation Cone 10
  • Brick Thickness 3''
  • Case Construction Stainless Steel, 3 clamps each
  • Assembly Screws Stainless Steel
  • Safety Agency Listing c-UL-us listed, Vent-Sure vent is also c-UL-us listed
  • Vent Downdraft, fumes under vacuum, motor on wall